top of page
All units ship complete with communication and power bus wiring factory installed and tested to allow for the fastest installation possible. The factory installation and pre-testing help eliminate any potential problems in the field. All in all, a faster, problem free, money saving and more efficient installation from start to finish!
Series 500 - Belt Conveyor
Standard
Specifications
Belt - 8", 12", 18", 20", 24" and 30" Black PVC 120 belt.
Bed - 12 gauge painted formed steel, 4" deep. Bed sections are 5 feet and 10 feet long bolted together with splice plates and floor supports.
Tail Pulley - 4" diameter crowned with 13/16" diameter shaft.
Drive Pulley - 4" diameter and 8" diameter crowned and fully lagged. 4" diameter pulley with 13/16" diameter shaft, 8" diameter pulley with 17/16" diameter shaft.
Snub-Roller - 2" diameter for 4" diameter pulley, 21/2" diameter for 8" diameter pulley.
Return Roller - 1.9" diameter adjustable on 10'0" centers.
Floor Supports - Adjustable 281/2" to 421/2" from floor to top of belt. One support supplied at each end of conveyor and at each bed joint.
Take-Up - 6" long screws located at tail pulley to provide belt tension.
Bearings - Sealed prelubricated with cast iron housings.
Speed Reducer - C-Face mounted heavy duty worm gear reducer.
Motor - 1/2 HP 230/460-3-60 TE motor.
Belt Speed - 60 FPM constant.
Capacity - Maximum load per lineal foot of conveyor - 75 lbs. Not to exceed Load Capacity Chart.
Optional
Equipment
Belt - Nitrile (white or black) with smooth top cover, Black PVC rough top, Brown Nitrile rough top.
Side Tables - 10", 16" or 22" wide formed steel side tables provide 12", 18" or 24" work area. Tables are supported by angles bolted to bed section.
Guard Rails - Adjustable channel, cont. channel, or solid steel guard rails available.
Floor Supports - Lower or higher than standard. Castered supports with 4" diameter or 6" dia. rigid or swivel casters.
Ceiling Hangers - 1/2" diameter threaded rods 8 feet long with locking nuts and mounting hardware. Other lengths are available.
Gravity Conveyor Brackets - Adjustable bracket with 13/8" diameter pop-out roller for attaching wheel or roller conveyor.
Nose-Over - Adjustable single or double nose-over provides smooth transfer from incline to horizontal.
Center Drive - Mounted below conveyor bed section. Can be placed most anywhere in conveyor length.
Side Mounted Drive - End drive mounted to side of conveyor section. Specify side. Minimum 6" elevation with 4" drive pulley, minimum 9" elevation with 8" drive pulley.
Overhead Drive - End drive mounted above conveyor. Clearance required.
Auxiliary Take-Up - Mounted below conveyor bed section. Can be placed anywhere in conveyor length.
Motor - Single phase, energy efficient, explosion proof, etc.
Belt Speed - Constant and variable belt speeds available.
Electrical Controls - Magnetic starters and push button stations; Manual motor starters with overload protection.
Standard Specifications
&
Optional Equipment
bottom of page