top of page
All units ship complete with communication and power bus wiring factory installed and tested to allow for the fastest installation possible. The factory installation and pre-testing help eliminate any potential problems in the field. All in all, a faster, problem free, money saving and more efficient installation from start to finish!
Series 300 - Lineshaft Coneyor
Standard
Specifications
Driving Belts - 3/16" diameter round urethane “O” rings from drive shaft to tread rollers.
Bed - 7" x 11/2" x 12 gauge painted steel channel frame with heavy duty cross braces and splice plates.
Rollers - 1.9" diameter x 16 gauge galvanized steel tread rollers with 7/16" hex shaft and sealed, greased for life bearings, spaced on 3" centers.
Floor Supports - Adjustable 311/2" to 451/2" from floor to top of tread roller. One support supplied at each end of conveyor and at each bed joint.
Drive - 2 foot module with motor and reducer. Drive module will be bolted to intermediate section.
Drive Shaft - 1" diameter steel shaft, driven by motor and reducer, runs full length of conveyor. Chain coupling supplied at bed joints to couple sections together.
Drive Spools - Delrin spools located on drive shaft supplies driving power to tread rollers.
Drive Shaft Bearings - Sealed, prelubricated, self aligning, precision ball bearings on drive shaft.
Speed Reducer - Integral gear motor drive mounted underneath conveyor with #50 roller chain connected to drive shaft.
Motor -1/2 HP 230/460/3-60 TE motor.
Drive Guard - Expanded metal guard full length of conveyor covers drive shaft and other moving drive components.
Conveying Speed - 60 FPM constant.
Capacity - 15 lbs. per tread roller maximum. Not to exceed Load Capacity Chart.
Optional
Equipment
Conveying Speed - Constant and variable speeds from 30 to 120 FPM available.
Timing Belt Drive - For speeds over 90 FPM a timing belt drive in lieu of #50 chain drive is recommended.
Roller Centers - Tread rollers can be placed on 4", 6", or 8" centers. NOTE: Capacities change as roller centers change. See engineering section of price list for capacity changes.
Floor Supports - Lower or higher supports available. Minimum elevation with standard drive mounting is 18" from floor to top of rollers.
Powered Right Angle Belt Transfer - Air operated pop-up round belt transfer mounted in 32" long modular section, 75 lbs. maximum unit load.
Package Stops - Manual or air operated blade or roller stops available.
Guard Rails - Adjustable channel or solid fixed guard rails available.
Motor - Single phase, energy efficient, explosion proof, etc. Other HP available.
Ceiling Hangers -1/2" diameter threaded rods 8 feet long with locking nuts and mounting hardware.
Jump Chain - One-to-one chain drive moves drive shaft
to opposite side for driving various optional accessories.
Standard Specifications
&
Optional Equipment
bottom of page