top of page

Best Used For...

  • Oily conditions

  • Drums

  • Positive drive

  • Pallets

All units ship complete with communication and power bus wiring factory installed and tested to allow for the fastest installation possible. The factory installation and pre-testing help eliminate any potential problems in the field. All in all, a faster, problem free, money saving and more efficient installation from start to finish!

Series 400 - CDLR Conveyor

Standard 

Specifications

Bed - Conveying surface width 28", 34", 40", 46", 52", 58", and 64". 21/2" diameter x 11 gauge and 25/8" x 7 gauge steel tread rollers, 11/16" hex shafts. No. 50 chain is used on 5", 71/2", 10" roller centers only. No. 60 chain is used on 6", 71/2", and 12" centers only. Tread rollers mounted in 4" and 6" x 4 gauge formed steel channel frame. Sections are bolted together with butt couplings and floor supports. 


Drive Chain - No. 50 roller chain or No. 60 roller chain can be used with either the 251 CRR or 267CRR as above. 


Floor Supports - Heavy duty supports are adjustable 301/4" to 40" from floor to top of roller. One support at every bed joint and each end of conveyor. 


Center Drive - Mounted underneath conveyor, center of section. Can be placed most any where in conveyor length. 


Bearings - Removable, sealed, prelubricated ball bearings. 


Chain Guard - Lower chain guard is mounted on bottom of roller frame, and upper chain guard is mounted above roller frame to totally enclose drive chain. 


Speed Reducer - C-Face mounted heavy duty worm gear reducer. 


Motor - 3/4 HP 230/460-3-60 TE motor. 


Speed - 30 FPM. 


Capacity - Maximum load per linear foot of conveyor; 300 Ibs. with supports on 10' centers, 1000 Ibs. with supports on 5'0" centers. 

Optional 

Equipment

Floor Supports - Lower or higher supports are available. Minimum elevation, 18" from floor to top of rollers. 


Side Mounted Drive - Motor-reducer unit can be mounted to side of conveyor frame. Drive is higher than conveyor frame. Minimum elevation to top of rollers is 7". 
Roller Set Low - 1 " x 11/2" x 7 gauge formed angle guard rail, bolted to top of non-driven side rail to provide 3/4" high guard rail. 


Motor - Single phase, energy efficient, explosion proof, 
etc. Other HP available. 


Roller Speed - Constant and variable speeds available. 


Electrical Controls - Magnetic starters and push button 
stations. Manual motor starters with overload protection, 
others. 

Standard Specifications

& 

Optional Equipment

bottom of page